Значения термина glass transition на английском

The phenomenon of the glass transition is an unresolved problem in condensed matter physics.

MA provided a plasticizing effect on the PA1010 matrix by decreasing the glass transition temperature.

The glass transition temperature of the polymer correlates with the morphology of the resulting scaffold.

The phenomenology of the spin model is similar to that of a supercooled liquid undergoing the glass transition.

In an effort to understand the glass transition, the dynamics of a nonrandomly frustrated spin model has been analyzed.

An entropy-vanishing transition, with the string density as the order parameter, is related to the observed glass transition in the spin model.

The physical state of each formulation was evaluated by determination of the glass transition temperature and residual moisture content, before and after storage.

The temperature dependent dielectric properties reveal the activation energy behaviour with reference to the glass transition temperature (80 °C) of PVA.

In fused alumina crucibles, glass transition temperatures rose to over 450 degrees C, with these values showing some convergence at higher furnace temperatures.

In contrast, the organic solvent did influence the film's properties; NMP-containing films had lower glass transition temperatures, adhesion and water resistance than ethanol-based ones.

We report on the observation of a glass transition in suspensions of very long and thin, highly charged colloidal rods (fd-virus particles).

Aggregation is not seen during incubation at temperatures below T(g)', and can also be avoided above the glass transition temperature under some conditions.

The residual solvent content and the glass transition temperature (Tg) of amorphous fluoropolymer membranes prepared with both solvents decrease with increasing drying temperature.

This study aims to investigate the relationship between caramelization of several sugars including fructose, glucose, and sucrose and their glass transition temperature (Tg).

The glass transition range shifted to higher temperature, from 75 °C to 133 °C, depending on the reduced amount of residual solvent.

The results show that with the addition of TiO(2) the density and glass transition temperature increased whereas the degradation and ion release properties are decreased.