1
Down the road, though, lead in solder may pose more esoteric concerns.
2
Blacken the piston rod in a candle flame to prevent solder adhering.
3
Perhaps the chief precaution necessary in making solder is to exclude zinc.
4
A drop of solder occasionally assists the process of setting the diamond.
5
Enough solder is used to completely float the tip of the iron.
6
In soldering, smoke the legs well to avoid solder adhering to them.
7
With a hot iron proceed to float the solder down the seam.
8
We take the bare PCB, apply solder paste, and assemble the parts.
9
Any grease or foreign matter will prevent the solder from running properly.
10
Noisebridge founder Mitch Altman shows first-time visitor Jay Thomas how to solder.
11
Sheet-metal joints must be double-seamed or riveted and thoroughly sweated with solder.
12
If, however, the solder is too cold, a ragged edge will result.
13
Alone, the Jinni sat at the workbench, measuring out solder and flux.
14
Mark any leaks by plain scratches, solder them up, and test again.
15
The dungarees were solder-stained, and there were holes burned into the shirtsleeves.
16
For laboratory purposes three kinds of solder are in general sufficient.
