1
If it won't enter, bevel off the sides of the cut very slightly till it will.
2
Then bevel off the outside corners and smooth them-aswell as the rest of the woodwork-withfine glass paper.
3
If it is a trifle difficult to pass, bevel off the edge slightly on the inside to make a fairly easy driving fit.
4
Then bevel off the end to 45 degrees and pass the tube through again, bringing the bevel up against the bottom hole from the inside.
5
Bevel off one end, and solder this to the plate.
6
Bevel off the ends of the last inside to allow the valve to enter easily.
7
A drop of the solution evaporated leaves crystals, either tetrahedric, or cubes with edges bevelled off.
8
It should be got with a square cutting edge, not beveled off as some are made.
9
Details.-Thetongues must be bevelled off to a point on the sides respectively nearest to the continuous rails.
10
The rear end of the cylinder should be bevelled off slightly inside, to allow the packed piston to enter easily.
11
The ends or the bottom are bevelled off towards the top edge to fit the grooves, so that no part may be above the grooves.
12
15 is a similar tool, but called a "corner grounder," as it is beveled off like a corner-chisel.
13
Three pieces, about 32 inches long each, have their ends bevelled off at an angle of 60 degrees, and are laid with their ends touching.